Rent Fluke Networks LANMeter Series 100 MHz Network Tester

Details

Fluke 100 MHz LANMeter Remote

Testing 100 ohm twisted pair with your Fluke LANMeter requires the optional 100 MHz remote adapter. If the optional 100 MHz remote adapter is used to test 100 ohm twisted pair cable, the results comply with EIA 568A, TSB-67 requirements for Level I test of Basic Link or Channel configurations.

Rent Fluke Networks LANMeter Series 100 MHz Rental

NEXT

The NEXT measurement requires the optional 100 MHz remote. For 100 ohm twisted pair cable the test performs a near-end crosstalk (NEXT) test at frequencies up to 100 MHz, depending on configuration.

Attenuation

The attenuation measurement requires the optional 100 MHz remote. Attenuation is a measure of loss of signal strength along the cabling link, and changes with the frequency of the signal. For 100 ohm twisted pair cable the test performs an attenuation test at frequencies up to 100 MHz, depending on configuration.